Lowering springs replace the factory springs to bring a car closer to the ground. They are the straightforward way to lose the wheel gap when you do not need a fully adjustable setup.
Springs or coilovers
Springs set one ride height and can be run with the factory dampers, which is why they cost less and fit faster. Coilovers replace the spring and damper together and let you adjust both ride height and damping, so you can tune the car rather than accept a single setting.
Springs suit an otherwise standard car where the goal is stance and a modest handling change. Coilovers suit someone who wants to set the car up properly, or who is going lower than a spring alone would take it.
What to expect
Lowering springs are usually a higher rate than the factory item. That is deliberate rather than a side effect: a car sitting lower has less suspension travel left before it runs out, so the spring has to work harder to keep it off the bump stops. The practical result is a firmer ride than standard.
They can be run on the factory dampers, but that is not the same as it being the best setup. A damper is valved for the spring it was built to work with, so a shorter, higher rate spring asks it to work outside what it was designed for. Where the dampers are already worn, expect them to wear faster still, and budget to do both at once rather than twice.
Wheel and tyre clearance is worth checking as well, since a lower car has less room before the guard makes contact on full lock or across a driveway.
Fitting
Springs are a workshop job. The car needs to be supported properly and the spring compressed safely. A wheel alignment afterwards is recommended, because changing ride height changes camber and toe, and on some cars the rear needs doing as well as the front.
Compliance
Ride height and suspension modification requirements are set by each state and territory and do change over time. Check what currently applies to your vehicle with your state or territory road authority before the car goes back on the road, use a certified engineer where one is needed, and tell your insurer about the modification.
FAQ
Are lowering springs better than coilovers? Neither is better. Springs are simpler and cheaper and set one height. Coilovers cost more and let you adjust height and damping. The right answer depends on whether you want to tune the car or just lower it.
Can I use them with my factory shocks? You can, and the springs are made to work that way. The damper is still valved for the original spring, so the ride will firm up and a tired damper will not last as long. If the car has covered big distance, do both together.
How much lower will the car sit? The drop is listed per product, because it differs by platform and sometimes front to rear. Check the listing for your car rather than assuming a figure.
Do I need an alignment afterwards? Yes, it is recommended. Lowering changes camber and toe, and leaving it unaligned wears tyres quickly.
Looking to Lower Your Car?
Can't see lowering springs for your vehicle? Our range is continuing to grow, and our team can help you explore the suspension options available for your car.
Get in touch with Automodellista to discuss your vehicle and the stance you're looking to achieve, or explore our wider range of performance upgrades.